Victron Quattro 12/5000VA 220A 100+100A inverter
Victron Quattro 12/5000VA 220A 100+100A is a charger inverter combination. Additionally it can accept two AC inputs and automatically connect to the active source Its many features include a true sine wave inverter, adaptive charging, hybrid PowerAssist technology plus multiple system integration features such as three or split phase operation and parallel operation.
Two AC Inputs & two AC Outputs
Victron Quattro 12/5000VA can be connected to two independent AC sources, for example shore-side power and a generator, or two generators. The Quattro will automatically connect to the active source. The main output has the “no-break” function (without interruption) In the event of a grid failure, or shore or generator power being disconnected, the Quattro takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption. The second output is live only when AC is available on one of the inputs of the Quattro. Loads that should not discharge the battery, such as air-conditioning or a water heater can be connected to this output.
Virtually unlimited power thanks to parallel operation
Up to 6 Quattros can operate in parallel to achieve higher power output. For example: 6 units of 48/10000/140, will five a output voltage of 48kW / 60kVA and capacity charge of 840 amp.
Three phase or split phase operation is also possible.
Two units can be configured for split phase output and three units for three phase output. But that’s not all: up to 6 sets of three units can be parallel connected to provide 96W / 120kVA inverter power and more than 1600A charging capacity.
PowerAssist – Boosting shore or generator power
The Quattro will prevent overload of a limited AC source, such as a generator or shore power connection. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.
Following and short control.
When coupled with a GX device (e.g. Cerbo GX) you can monitor and control your Quattro and system or systems’ locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM app and free VRM portal website Access can be from a phone, tablet, laptop or PC for multiple operating systems. There is no end to the level of control, from adjusting your Quattro to auto starting a backupgenerator and more…
– In case of a stand-alone application, if settings have to be changed, this can be done in a matter of minutes with a DIP switch setting procedure.
-Parallel and three phase applications can be configured with VE.Bus Quick Configure and VE.Bus System Configurator software.
-Off grid, grid interactive and self-consumption applications, involving grid-tie inverters and/or MPPT Solar Chargers can be configured with Assistants (dedicated software for specific applications).
Data sheet of the Victron Quattro 12/5000VA 220A 100+100A inverter
See the data sheet for more information HERE